| Power Requirements |
2-wire, 24-29 volts DC, minimum 250 ohm loop
resistance. Motor 3 phase 440-480 VAC @ 60 Hz
Optional 110VAC Single Phase @60Hz available |
| Output Signal |
4-20 mA (limited to 23 mA) into 350 ohm max. load @ 24 volts,700 ohms @ 29 volts. |
| Output Dampening |
Digital 1.5 to 100 seconds( 5 sec. factory setting ) |
| Output Jacks |
4 to 20 ma. Equal Upper & Lower Range |
| Pulp Curves |
TEN Calibration curve, 1 to 7% installed in transmitter. Curves selection via HART.
Span (Min. 1% Max. 5% ) |
| Sensitivity |
Better than +/- 0.025% as % consistency |
| Repeatability |
+/- 0.3 % full scale (constant operating conditions) |
| Operating Conditions |
Max. stock Temp. 140 °F - Ambient Temp.140°F |
| |
Max. Process Pressure @ 257°F |
| Materials |
Wetted Parts : 316 S/S - Housing : Aluminum |
| Seal Cooling |
Self-Contained cooling using heat transfer fluid.
No external water required.
|
|
Consistency Range adjustments made in % consistency from any HART device such as a Rosemount™ 275/375 Communicator.
|
| Consistency Sensing |
Standard Motor Driven Disc and Shaft to Generate Torque from Consistency changes. |
| Torque Sensing |
Non-Contact Inductive coupling with Stationery Pick-Up Coil; approximately .030 in Air Gap. |
MAGIC III
Upgrade |
Can be installed on any existing pneumatic or electronic BTG® transmitter. |
